#1. Which command you use to set the flow percentage?

#2. What is the last line in your G-code?

#3. Which G-code command was used to pause your print?

#4. If you desired a pause not controller by time but by user input what command should you use?

#5. Which G-code commands you used to change the filament?

#6. When changing filaments, what filament temperature should you set the extruder to?

#7. When changing filaments, what filament temperature should you set the extruder to?

Finalizar

Resultados

Congratulations! It was a hard one, but you passed!

You must repeat the exam